Copyright © Kunshan Pinhong EPT Co.,Ltd All rights reserved. Site Map Designed by iwonder.cn
Kunshan Pinhong EPT Co.,Ltd
Kunshan Pinhong EPT Co.,Ltd
Add : (Qiandeng Yuanchuang Base) No. 125, Jinxing South Road, Qiandeng Town, Kunshan, Jiangsu, China
Tel : （0086）15995617314
Fax : +86-512-50130524
E-mail :lvfang@ksphxs.com
The disc aerator is a horizontal axis surface aeration device, and the brush disc is evenly fixed on the main shaft. Driven by the driving device and the water mixture, the brush plate starts to rotate along the main shaft, and the water droplets are thrown into the air to complete the aerobic process. It promotes the circulation flow in the oxidation ditch.
Product Description:
Disclosed is a disc microporous aerator for improving the oxygen content of sewage treatment. As air passes through the device, it is divided into countless small bubbles.
Product advantages:.
1. The aeration pan gland is designed with a downward protrusion along the end, and there are several rods on the outer side of the protrusion and inside the groove supporting the coil. The diameter of the diaphragm line is thickened to 10mm. After the product is assembled, lift the gland, firmly fix the diaphragm in the groove of the support plate, and use the ribs to snap into the inner rubber diaphragm to seal and lift the diaphragm firmly to prevent the diaphragm from falling off .
2. The root of the thread of the disc aerator is strengthened to prevent the thread from breaking. The optimized design of the air duct structure, the expansion of the air hole area, and the chamfering design of the corners reduce the resistance loss of the product under working conditions. .
3. There are 6 "L" shaped grabs around the aerator gland. Under the working conditions of the aerator, it can prevent the membrane from falling off due to the creep of the plastic gland due to the expansion pressure of the membrane for a long time.
4. The optimized design of the air duct structure, the expansion of the air hole area, and the chamfering design of the corners reduce the resistance loss of the product under working conditions.